Christmas Tree Card Holder

Christmas Tree Card Holder
I looked around for quite a while for inspiration for this project, and I found an idea like this one at Moda Bake Shop. They used their fabric, which I absolutely love, however, I didn’t have any fabric on hand. I decided to settle for scrapbook paper and foam board.

Supplies:

  • Foam Board, 1 Piece
  • Scrapbook Paper, Christmas Themed
  • Adhesive Squares
  • X-Acto Knife
  • Ruler or Measuring Tape
  • Ribbon
  • Brads

Instructions:

Step 1:  Measure to the center of the foam board and make a small mark.

Measure

Step 2:  Measure about 9 1/2″ from the bottom and put marks there. This will be the line you will use to connect to form the sides of the tree.

From Bottom

Step 3: Draw the lines to connect the sides to the top. Measure 7″ in on each side to create the trunk of the tree and then 3″ vertical to the bottom. Complete by drawing a line across the bottom. It should look like this.

tree

At this point, it sort of resembles an arrowhead more than a Christmas Tree. haha!

Step 4:  Cut around the shape with your x-acto knife.

xacto

Step 5: Using a paper cutter, cut your paper into 4-inch squares. Place them on the tree. Using adhesive squares, glue them down.

adhesivesquares

Step 6:  Add ribbon. I added a piece of ribbon at the bottom to create a nice clean edge. I also spaced the brown ribbon across and added the brads to create separation so that the cards would stay when put int he card holder.

ribbon

Here is another photo of the finished project!

Card Holder

2 Comments

  1. Sadie Lankford says:

    Super cute! This one should be on Tip Junkie, too! :)

  2. This is super cute! Great job!

Leave a Reply to Sadie Lankford Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.